Execution sequence
1. Remove the front bumper with grille. We mark the position of the lock with a marker.
2. Using a 13 mm socket or spanner wrench, unscrew the two nuts securing the lock.
3. Remove the lock from the studs and disconnect the rod from the lock.
4. We install the lock in the reverse order in accordance with the mark made. Before installing the front bumper, we check the operation of the lock. For this:
5. Cover the hood (the latch on the hood must fit into the slot of the lock in the center).
6. If necessary, loosen the fastening nuts and, having mixed the lock to the right or left, adjust its position. After adjusting the position of the lock, slam the hood (it should close tight). The density of the hood closing is adjustable by moving the lock up and down.
7. If necessary, adjust the height of the hood stops.