Designations on the identification (factory) plate:
- AVTOVAZ- name of the manufacturer JSC «AVTOVAZ».
- VERSION - modification.
- ENGINE - car engine.
- № FOR SPARES - NO. FOR SPARE PARTS.
A - progressive number of the car exit from the assembly line.
The number for spare parts corresponds to the serial number of the car leaving the assembly line. When ordering spare parts, please refer to the information on the identification (factory) plate.
b - gross vehicle weight.
V - vehicle identification number and body number.
The identification number is deciphered as follows: the first three letters, according to international standards, indicate the manufacturer's code; the next six digits are the car model; letter of the Latin alphabet (or a number) - the model year of the car; the last seven digits are the chassis number, for a passenger car corresponding to the body number. In accordance with the Technical Regulations «About the safety of wheeled vehicles» the model year is defined as the conventional year specified by the manufacturer (usually following the actual year of manufacture of the vehicle). In JSC «AVTOVAZ» The start of the model year is set on October 1 of the calendar year. Thus, from January 1 to September 30, the model year corresponds to the actual year of manufacture of the car, and from October 1 to December 31, corresponds to the year following the actual manufacture of the car.
The identification number is duplicated on the right support of the telescopic front suspension strut.
G - vehicle type approval number.
It is given in full in the vehicle passport.
d - engine model.
The engine model and number are also stamped on the end face of the cylinder block, above the clutch housing.
e - permissible weight of the car with a trailer.
and - the maximum permissible load on the front axle of the car.
h - the maximum permissible load on the rear axle of the car.
And - two-digit index of the variant.
To - a three-digit configuration code.
In the variant, a plastic identification is added (factory) plate. The letter designations in the figure of the plastic plate should be read as follows:
- a - vehicle designation;
- b - engine designation;
- in - number for s / h;
- g - sign of circulation on the market;
- e - name of the manufacturer;
- e - vehicle type approval number;
- g - identification number;
- h - technically permissible maximum mass of the vehicle;
- and - technically permissible maximum mass of the road train;
- k - technically permissible maximum axial mass on the front axle;
- l - technically permissible maximum axial mass on the rear axle.