Replacing the remote control battery

The remote control contains a lithium battery type CR2032, the initial supply voltage of which is 3 Volts. If the remote control supply voltage is within the normal range, then each time you press any button on the remote control, the remote control indicator lights up with a short flash. If, when pressing any button on the remote control, the indicator lights up with two short flashes or does not light up at all, then you should replace the battery with a new one. To do this, do the following:

• remove screw 2 (pic. 55) from the side of the body opposite the control buttons:
• using a flat screwdriver, separate the housing halves by inserting a screwdriver into slot 1;
• remove the board from the case;
• replace battery 3 with a new one, observing the connection polarity;
• insert the board into the case;
• snap the housing halves and tighten the screw 2.

Attention! The remote control cannot use any other type of battery.