Exterior (external body parts) Lada Kalina 1

Body design features
The body of the car Lada Kalina sedan type, load-bearing, four-door, consists of a frame and attachments. body frame (pic. 10.1) includes base, sidewalls, roof and frame parts connected by electric...

Body malfunctions, their causes and solutions
Cause of malfunction Remedy Dark spots all over body Hot water body wash application (above 80°C) Using leaded gasoline or other corrosives to remove body wax Repair minor damage to the body by...

Removal and installation of a radiator grille
You will need a Phillips screwdriver to remove and install the grille on your vehicle. 1. Turn out three screws of fastening of a radiator lattice to a body. 2. Raise the radiator grille, disengaging...

Removal, replacement and installation of the front bumper
To remove, replace and install the front bumper on the car, you will need: Phillips screwdriver, wrench «on 10», socket wrench «at 13». 1. Remove the grille (see « Removal and installation of a...

Removal, replacement and installation of the rear bumper
To remove, replace and install the rear bumper on the car, you will need: Phillips screwdriver, wrench «on 10». 1. Turn out four screws of fastening of a mudguard of a back wheel. 2. Remove the rear...

Removal and installation of a forward fender liner
To remove and install the front fender liner on the car, you will need: Phillips screwdriver, wrenches «for 8», «on 10». 1. Turn out three screws of fastening of a mudguard of a forward wing... 2.......

Removal, replacement and installation of the front wing
To remove, replace and install the front fender on a car, you will need: socket wrenches (heads) «for 8» And «on 10», knife. 1. Disconnect the wire from the terminal «minus» battery. 2. Remove the...

Removal, replacement and installation of a cowl
To remove, replace and install the hood on a car, you will need: a flat-blade screwdriver, a wrench «at 13». 1. Remove the hood latch and safety hook (see « Removal and installation of the lock of a...

Removal and installation of the lock of a cowl and a safety hook
To remove and install the hood latch and hood latch safety hook on your vehicle, you will need: «at 13», screwdriver with a slotted blade, pliers. 1. Loosen the hood pin locknut... 2.... unscrew the...

Replacement of draft and the handle of opening of the lock of a cowl
You will need a key to replace the pull rod and the hood release handle on a car «at 13». 1. Remove fender liner (see « Removal and installation of a fender liner »). 2. Remove the tip of the shell...

Hood lock adjustment
To adjust the hood lock on a car, you will need: a flat-blade screwdriver, pliers. 1. Signs that the hood lock needs to be adjusted in height are a large effort when closing the hood and vertical...

Removal and installation of facings of a frame of a windscreen
To remove and install windshield frame trims on a vehicle, you will need: Flat and Phillips screwdrivers. 1. Remove the two decorative plugs of the screws securing the right windshield frame trim......

Removal and installation of an external rear-view mirror
To remove, replace and install the outside rear-view mirror on a car, you will need: screwdrivers with a flat and cross-shaped blade, pliers. 1. Remove a decorative overlay of a lateral rear-view...

Control dimensions of the body type sedan
Pic. 1. Control dimensions of door openings Pic. 2. Checkpoints of the body in the engine compartment Pic. 3. Control dimensions of the windshield opening Pic. 4. Control dimensions of the rear...