To remove and install the air filter on a car, you will need: «on 10» (more convenient end), Phillips screwdriver, pliers or knife.
1. Disconnect the wire from the terminal «minus» battery.
2. Disconnect the wiring harness connector from the MAF (mass air flow sensor) (see point 2 «Replacing the air filter element»).
3. Loosen the air inlet pipe clamp and disconnect the pipe from the DMRV sensor.
4. If you remove the air filter for replacement, and the mass air flow sensor is not installed on the new filter, unscrew the two sensor mounting bolts, remove the sensor from the filter...
5.... and the sealing ring of the DMRV sensor.
6. Turn away a nut of fastening of an air inlet pipe to a radiator frame.
7. Turn out two bolts of fastening of the air filter to a radiator frame...
8.... remove the head of the air filter rubber support from the bracket hole on the battery mounting shelf...
9.... and remove the air filter assembly with brackets and air intake pipe.
10. If necessary, remove the air intake pipe from the air filter housing, overcoming the elastic resistance of plastic parts.
11. If you are replacing the air filter on the car, remove the rubber supports together with the brackets from the holes in its housing by squeezing the conical shank of the supports with pliers. Install the supports with brackets on the new air filter, lubricating their shank with engine oil to facilitate installation.
12. Establish on the car the air filter and all removed details in an order, the return to removal.