Car gearbox Lada Kalina 1

Reference data on the elements of the gearbox
Table 9.2.1. Basic data for control, adjustment and maintenance * The seals of the left and right drives are not interchangeable, as they have a different direction of the oil drain grooves. Table...

Description of the design of the gearbox
The car is equipped with a mechanical five-speed two-shaft gearbox. It is mounted together with the main gear and the differential into a single unit, the body of which consists of three parts - the...

Checking the technical condition of the gearbox
Before proceeding to check the technical condition, check the oil level in the gearbox (see « Transmission - Checking the Oil Level »). In a box operated with a low oil level in the crankcase,...

Gearbox — checking the level and changing the oil
We check the oil level in the gearbox during vehicle maintenance, as well as before each trip if oil leaks from the gearbox. To complete the work you will need: viewing ditch or overpass; wide...

Jet thrust — removal and installation
Attention! Work is carried out after the additional muffler has cooled down to a safe temperature. To perform the work, an inspection ditch or overpass is required. Removing 1. We prepare the car for...

Gearshift drive — removal, disassembly, installation and adjustment
Comment. Removal of the gear shift actuator may be required when replacing defective parts (e.g. to replace a torn drive rod boot, a damaged drive rod). The sequence and number of operations...

Reverse lock solenoid — check and replace
To complete the work you will need: viewing ditch or overpass; multimeter. Examination 1. We prepare the car for work (see « Preparing the car for maintenance and repair »). 2. Remove the engine...

Front wheel drive oil seals — replacement
Comment. The drive seals can be replaced without removing the gearbox from the vehicle. Warning! Left and right drive seals are not interchangeable (catalog numbers: right oil seal - 2110-2301034 or...

Input shaft oil seal — replacement
When the input shaft seal is worn, the oil from the gearbox enters the clutch housing. In this case, the clutch discs may be oiled. A malfunction can be determined by the presence of smudges from...

Gearbox — removal and installation
Recommendation. The gearbox weighs more than 30 kg, so work with an assistant or using an adjustable stand or lifting device. Warning! Do not remove both drives at the same time or, if necessary,...

Wheel — replacement
To complete the work you will need: «balloon» or socket wrench 17 mm; jack; anti-recoil stops; jack support (if the machine is standing on loose ground). Execution sequence 1. We install the car, if...