Equipment and Electrical Appliances Lada Largus 1

General description of the electrical equipment of the car
All main electrical circuits of the vehicle are protected by fuses. It is worth noting that in the event of a fuse blown, and even more so in the event of a repeated blown fuse, it is necessary to...

Instrument cluster — removal and installation
Removing Place the car on the workplace, brake with the parking brake, turn off the ignition. Raise the hood, disconnect the wire terminal "masses" from battery (wrench "on 10"). Remove decorative...

Disassembly of the electric outside rearview mirror
We disassemble the outside rear-view mirror to replace the reflective element of the mirror with a heating element, the gear motor unit or the mirror lining. The work is shown on the left mirror, on...

Removing front and rear windshield washers
Note. Front washer part numbers see here , and rear washer see here . Please note that the pump (little motor) windshield washer is different depending on the presence of the rear washer, i.e. may...

Windshield wiper — removing levers and electric motor
See part numbers for this unit. here . Windshield wiper: 1 - a leash with a brush lever shaft; 2 - long traction; 3 - bracket; 4 - motor-reducer; 5 - air cleaner mounting pad; 6 - short pull Removing...

Removing the tailgate rear wiper
Note. Rear wiper part numbers see here . The rear wiper is installed on the left tailgate, under the trim. The cleaner consists of a motor-reducer, a lever and a brush. The electric motor of the...

Fuses — location, rating and purpose
Fuses are located both in the cabin and under the hood. Most of them are in the salon. Fuse box in the cabin block 1, (figure 14-2), the fuse box is installed in the passenger compartment on the left...

Center console with instruments — removal and installation
Removing Place the car on the workplace, brake with the parking brake, turn off the ignition. Raise the hood, disconnect the wire terminal "masses" from battery (wrench "on 10"). Remove the central...

Radiator fan motor replacement
1. Disconnect the terminal «minus» battery. 2. Remove the engine cooling fan ( see here ) 3. Key "on 10" unscrew the nut securing the fan impeller to the motor shaft by turning the nut clockwise...

Removing the driver's airbag (SRS, Airbag)
see also Removing the passenger airbag . Note. Pillow part number see here. Disconnect the terminal "minus" from the battery. Wait 10 minutes for the airbag activator capacitor to discharge. Warning!...

Removing the front passenger airbag (SRS, Airbag)
see also Removing the driver's airbag . The front passenger airbag differs from the driver's airbag in its shape and relatively large volume. Disconnect the terminal "minus" from the battery....

Removing the electronic airbag control unit
Note: unit part numbers see here . The airbag control unit is installed under the front of the central floor tunnel. Remove the front of the floor tunnel ( see here ). Fold back the carpet. key...

Seat heating switch — removal and installation
Removing Place the car on the workplace, brake with the parking brake, turn off the ignition. Raise the hood, disconnect the wire terminal "masses" from battery (wrench "on 10"). Figure 16-1 - Seat...

Speakers (audio speakers) front — removal and installation
Note. front and rear door audio speaker part numbers see here . Removing Place the car on the workplace, brake with the parking brake, turn off the ignition. Raise the hood, disconnect the wire...

Radio — removal and installation
Removing Place the car on the workplace, brake with the parking brake, turn off the ignition. Raise the hood cover, disconnect the wire terminal "masses" from the battery. Figure 17-3 - Radio device:...

Radio antenna — removal and installation
Note. antenna catalog number see here . Place the car on the workplace, brake with the parking brake, turn off the ignition. Raise the hood, disconnect the wire terminal "masses" from battery (wrench...

UCH (central electronic switching unit in saloon)
Switching block (controller) located in the cabin, on the left under the instrument panel. Note. do not confuse this block with ECU controller . Part numbers for this assembly see here . Removing...

Instrument panel wiring harness — removal and installation
see also Wiring harness location . Removing Put the car on a two post lift (electrohydraulic hoist type P-3.2 G with a lifting capacity of 3.2 tons). Apply the parking brake, turn off the ignition,...

Rear wiring harness — removal and installation
see also Wiring harness location . Removing Put the car on a two post lift (electrohydraulic hoist type P-3.2 G with a lifting capacity of 3.2 tons). Apply parking brake, turn off the ignition, raise...

Ignition wiring harness — removal and installation
Removing Place the vehicle on a two-post lift, apply the parking brake and turn off the ignition, (electrohydraulic hoist type P-3.2 G with a lifting capacity of 3.2 tons). Remove battery 1, Figure...

Wiring harness left loading door — removal and installation
see also Wiring harness location . Removing Place the car in the workplace, brake with the parking brake, turn off the ignition, raise the hood, disconnect the wire terminal "masses" from battery...

Front bumper wiring harness — removal and installation
see also Wiring harness location . Removing Place the car in the workplace, brake with the parking brake, turn off the ignition, raise the hood, disconnect the wire terminal "masses" from battery...