Removing
Place the car on the workplace, brake with the parking brake, turn off the ignition. Raise the hood, disconnect the wire terminal "masses" from battery (wrench "on 10").
Interior lighting dome
Open the front door of the car.
Remove diffuser 2, Figure 12-1 (flat screwdriver).
Press the latch 2, Figure 12-2, and remove the dome light from the vehicle roof upholstery.
Figure 12-1 - Interior lampshade: 1 - body of the ceiling lamp for interior lighting; 2 - diffuser; 3 - switch
Figure 12-2 - Removing the interior lampshade: 1 - switch; 2 - latch; 3 - lamp
Disconnect connector 1, Figure 12-3, of the instrument panel wiring harness from the dome light.
Figure 12-3 - Disconnecting the front wiring harness connector: 1 - front wiring harness block to the interior lighting dome
To replace the lamp 3, Figure 12-2, pull it towards you and remove from the housing 1, Figure 12-1, the dome light.
Note: Use only certified W5W bulb for replacement.
Cargo compartment lighting (for car van)
Remove diffuser 2, Figure 12-4 (flat screwdriver).
Figure 12-4 - Plafond for lighting the cargo compartment: 1 - body of the ceiling light for lighting the cargo compartment; 2 - diffuser; 3 - switch; 4 - latch
Release lock 4 and remove the cargo compartment light from the upholstery of the car body.
Disconnect the wiring harness connector from the cargo area dome light and remove the dome light.
To replace the lamp, pull it towards you and remove it from the body of the dome light in the cargo compartment.
Note: Use only certified W5W bulb for replacement.
Installation
To install the lamp and the dome light for the passenger compartment and the dome light for the cargo compartment, proceed in the reverse order of removal.