Replacement of brake pipes

You will need: a special key «on 10» for unscrewing the nuts of the brake pipes, wrench «at 13».

1. Turn away tubes from the main cylinder and brake hoses. Plug the master cylinder and hoses.



2. Unscrew the three nuts securing the plastic pipeline protection..



3.... and remove the protection.



4. Use a screwdriver to pry off the fixing tabs of the metal plates of the tube holders..



5.... and remove the plates.

6. Turn away nuts of fastening of tubes to knots of brake system and take out tubes from holders. Replace broken holders.

Note. To remove the rear right brake pipe, you must remove the fuel tank (see «Replacing the fuel tank and its filler pipe»).

7. Install new tubes in reverse order and bleed the brake system (see «Bleeding the hydraulic drive of the brake system»).