You will need two keys «at 13».
1. Install the vehicle on an inspection ditch or overpass.
2. Check the position of the parking brake lever, which should be in the lowest position.
3. Loosen the locknut while holding the tensioner adjusting nut with another wrench.
4. Screw the adjusting nut 1, holding the stem 2 with pliers until the parking brake cable is tightened.
5. Verify that the full travel of the parking brake lever is 2-4 clicks.
6. After checking travel, tighten the equalizer locknut while holding the adjusting nut with a wrench.
7. Lower the parking brake lever all the way down and turn the rear wheels by hand. They should rotate evenly, without jamming. If during the adjustment process it is not possible to tension the parking brake cable, it must be replaced.
Note. With the parking brake properly adjusted, the brake drums should not heat up while the vehicle is moving without braking.