Removing
1. We prepare the car for work and install it on a viewing ditch or overpass (see «Preparing the car for maintenance and repair»).
2. Disconnect the wire terminal from the negative terminal of the battery (see «Battery - removal and installation»).
3. Remove the auxiliary drive belt from the generator pulley (see «Accessory drive belt - check and replace»).
4. Remove the engine mudguard (see «Mudguard of the engine - removal and installation»).
5. Press the latch and disconnect the wire block from the generator.
6. Using a 13 mm wrench, unscrew the fastening nut and remove the wire tip from the generator output.
7. Using a 10 mm wrench, unscrew the two bolts of the lower...
...and two top mounting bolts.
8. Remove the generator.
Installation
Install the generator in reverse order.